Replace your S1 Lifer Helmet Sizing Liners with some fresh, durable, washable and sweat absorbing Terry Liners.
The S1 Lifer Terry Liner is a sewn terry cloth replacement sizing liner for the Lifer Helmet. The terry cloth is sewn onto the liner, sealed at the ends and covers the front and back of the liner making it more durable allowing it to not break down as fast as the standard Lifer sizing liners.
The terry cloth also helps absorb sweat and is washable. We recommend rinsing the Terry Liner under cold running water with or without light soap, wringing them out and air drying them.
The sizing of the S1 Lifer Terry Liner is exactly the same as S-1's standard liners and are compatible with all Lifer Helmet Shells including the standard Lifer, Mini Lifer and Mega Lifer. For a complete breakdown of S-1's helmet sizing go to S-1's Pick A Helmet Page.
One set of Terry Liners come with a back and front sizing liner at Velcro to attached it to the inside of the helmet.
*** Installation Notes ***
Run small. Order one size smaller than your normal S-1 helmet size.
If you are adding these terry liners into a helmet that you have already worn please wash the contact points wear you plan to place the new Velcro with a wet cloth to wipe away any sweat residue that may have built up on the surface of the inner helmet shell. Doing this will ensure that the Velcro will stick firmly to the inner shell.